Level 1 and 2 Service ManualDisassembly
5. Insert the disassembly tool into the openings on the flip housing to release the
2 latches on each side of the flip assembly. (see Figure 17).
Flip Housing Catch
Flip Assembly
Flip Housing
Catch
Flip Housing Catch
0051428o
Figure 14. Removing the Display Lens
6. Carefully lift the flip cover away from the flip assembly. Avoid damaging the
display flex cable and connector.
7. To replace, align the flip cover with the flip assembly. Press the flip cover onto
the flip assembly until the 5 latches are fully engaged.
8. Insert and tighten the 4 flip screws with the T5 driver to a final torque setting
of 13 Ncm. Do not overtighten.
9. Remove the adhesive from the back of the new display lens and apply lens to
the flip housing.
10. Replace the flip assembly, keypad assembly, transceiver board assembly, rear
housing, antenna, SIM, battery, and battery cover as described in the
procedures.
6809497A14-O November 10, 2005 31 |