Motorola BMC User Guide
Installation Wrap-Up
1. Verify that all cable connections are tight and secure, all coaxial connections are finger-tight and
properly seated, and that all RCA-style plugs are fully seated.
2. Ensure that nothing blocks the vents of the BMC or other equipment.
3. Plug the TV power cord into the wall outlet.
4. Attach one end of the power cable to the BMC Power port and plug the other end into the wall
outlet.
During the start-up process, a sequence of numbers may appear on the front panel display (where the
time appears normally). This display is designed to help troubleshoot the system. If the BMC is unable
to complete the startup process, please note the number shown on the display and refer to it when
speaking with your cable provider's customer support representative.
Depending on the type of TV and connection used, you may need to tune the TV to the proper
channel or set the video input source. Refer to your TV user manual for details.
The Moxi splash screen on the TV indicates a successful installation. Allow the unit approximately three
minutes to fully start, and then configure the audio and video software settings using the information
in the next two sections.
NOTE Once the BMC is turned on, you never need to turn it off. Unless you are moving the BMC or
having it serviced, you should leave it powered on at all times to ensure that scheduled
recordings are not interrupted.
Audio Configuration
When your cable company installs your system, they configure your audio setting for you. However, if
you upgrade or change your sound system, you must reconfigure the BMC?s audio output.
1. Press the MOXI button on the remote to bring up the Moxi Menu.
2. Go to Settings and choose Digital Audio.
3. Bring the desired setting into center focus, and then press OK to select it.
4. Choose one of the following:
If your system uses an S/PDIF connection, choose Dolby Digital for digital audio support.
If your system has a typical Red/White dual composite cable connection, choose Stereo.
The following table represents the audio format supported by each type of physical connection
available on the BMC.
Supported Audio Formats
Audio connection Supported audio
Stereo Dolby Digital
S/PDIF Audio 9 9
Stereo Audio (L/R) 9
10 |
ACEC
